This new helmet from Pyrotect is one of the best bang-for-the-buck helmets available. It is designed by Bell Helmets and is very similar in design to helmets like the Bell M2. Unlike some auto racing helmets, it is NOT a re-worked motorcycle helmet.

Standard Features:
-Patented air-flow liner that is fully removeable/washable!
-Thin or thick cheek pads can be ordered separately for custom fit
-Fiberglass construction
-Large eyeport w/ .125 flat polycarbonate shield w/multi-step ratcheting pivots
-Uses standard BELL tearoffs
-Available in white or black
-Snell SA2005 rating

BEFORE ORDERING:
Measuring the head is a starting point for the entire sizing procedure. Due to varying shapes, heads that are apparently the same size when measured by a tape may not necessarily fit the same size helmet.The circumference of the head should be measured at a point approximately one inch above the eyebrows in front and at a point in the back of the head that results in the largest possible measurement. Take several measurements to make sure you have the largest one. This is the size to compare on the chart below.

NOTE: If you have facial hair (beard) or an unusually thick head of hair, you may want to consider ordering 1 size up from what is shown on the sizing charts if you are near the top of your size range.



Priced individually