This lightweight open face helmet from Pyrotect is made of composite fiberglass and has a plush comfortable interior that is removeable/washable. This helmet is very similar in design to the Bell Mag 4 helmet.

Standard Features:
-Patented air-flow liner that is fully removable/washable!
-Thin or thick cheek pads can be ordered separately for custom fit
-Fiberglass construction
-Open face design
-Available in white or black
-Snell SA2005 rating (M2005 version also available)

BEFORE ORDERING:
Measuring the head is a starting point for the entire sizing procedure. Due to varying shapes, heads that are apparently the same size when measured by a tape may not necessarily fit the same size helmet.The circumference of the head should be measured at a point approximately one inch above the eyebrows in front and at a point in the back of the head that results in the largest possible measurement. Take several measurements to make sure you have the largest one. This is the size to compare on the chart below.

NOTE: If you have facial hair (beard) or an unusually thick head of hair, you may want to consider ordering 1 size up from what is shown on the sizing charts if you are near the top of your size range.




Priced individually