A Pillar Graphics: Union Jack

Details

If you're looking for a bit of contrast similar to the images on the left (black pattern on black a pillar) you likely want to select the "Matte Black" option from the drop down menu as the "Gloss Black" finish will be very similar to the finish of the existing A Pillar and may not be as noticeable as the Matte finish will be on the gloss A pillar (the part already on your MINI that these stick to).

The white options will have plenty of contrast and either the option for Glossy White vs Matte White will just be a visual preference.

 INSTALLATION NOTES:
1. START BY CLEANING THE SURFACE
2. POSITION AND TEST THE GRAPHIC ON THE SURFACE DO NOT SEPARATE LINER FROM PRE-MASK This is to insure proper placement before the liner is removed.
3. SEPARATE LINER FROM PRE-MASK. As needed rub down the graphics from the transfer tape side with a credit card.
4. Spray the area where the graphics are to be installed with a water. This will allow the graphics to be positioned and allow air bubbles to escape. CAREFULLY PLACE THE VINYL GRAPHIC (WITH PRE-MASK/transfer tape) ON THE SURFACE
5. USE SQUEEGEE TO APPLY VINYL GRAPHIC WORK FROM THE CENTER OUT TO push the air bubbles outward.
6. REMOVE PRE-MASK
7. SQUEEGEE OVER THE ENTIRE GRAPHIC and peel back the transfer tape at a angle being cautious to make sure the graphics are not lifting up. If they are wait 10-30 minutes and try again.
See drop down menu for options.

R-Fifty WHAT?? Confused about what model MINI you have? We’re here to help. Check this out for more information.