Excellent fit. I bought the matte black to try and match the rest of the trim and it looks factory installed.
Removing the OE chrome grill "nuts" was a bit of a pain, so I elected to just snap the plastic threads off rather than attempt to remove them. I wouldn't plan on keeping the OE grill as the plastic threads and stamped nuts are practically destroyed no matter how gentle you are.
The upper grill snaps in and use the same fasteners as the OE. The new stamped nuts can be a bit annoying, just seat the nut on the ball of your thumb and turn. Once the nut cuts into the plastic use a nut-driver to snug up--don't over tighten.
The lower grill just snaps in. I cleaned and plasti coted the bumper black, as you can see the bumper color behind the new grill--my car is red so it really stood out.
This grill makes the car look so much better and more up to date. I really like it.
*plasti-cote is your new best friend*
All I can say is wow! This sway bar installed easily. The NM Engineering instructions are excellent. I could feel the difference even backing out of the garage. I started it out on setting 3 out of 4, but will be moving to the stiffest setting shortly. The Mini handled great stock, so I was a little skeptical about how much of a difference this bar would make. Boy am I glad I elected to give it a try. Completely worth the expense.
These camber plates are very well built structurally, improved the handling of the car dramatically, but IE built this unit around a very low quality bearing. By increasing the camber in the way that this unit does, it puts more load on the bearing and within only a couple months of installing it, the bearing becomes noisy, than gets sloppy, and than you car sounds like your front end is going to fall off on mild bumps. We installed these fixed camber plates following the instructions to the letter and within a few months, every set had to come off the cars they were on.