Product reviews: LED License Plate Light Set: Gen1

Thanks so much, I installed the MSD coil, MSD 8.5 mm wires and Iridium plugs. Mini runs much better, even idles at lower rpms and seem smoother in all gears.
I'm thinking it will pay for it's self in gas saving in short order.
Thanks again for offering these products.
Best Regards,
Ron Garcia

Ron

These camber plates are very well built structurally, improved the handling of the car dramatically, but IE built this unit around a very low quality bearing. By increasing the camber in the way that this unit does, it puts more load on the bearing and within only a couple months of installing it, the bearing becomes noisy, than gets sloppy, and than you car sounds like your front end is going to fall off on mild bumps. We installed these fixed camber plates following the instructions to the letter and within a few months, every set had to come off the cars they were on.

Vic Gregory
(Vehicle Programming)

Both of the front headlight trims came with one having the letter "A" and one having the letter "B" but does not instruct on which one is left and right side. Both pieces are almost identical and fit nearly the same on either headlight trim. I feel that there should be some sort of instruction on which one goes on the left or right side.

Patrick

View All Testimonials

Write Your Own Testimonial

LED License Plate Light Set: Gen1

		(1 reviews)

5 stars:		1 review(s)
4 stars:		0 review(s)
3 stars:		0 review(s)
2 stars:		0 review(s)
1 stars:		0 review(s)

If you have purchased this item and would like to leave a product review please sign in to add your review.

Be Social

Reviews

Testimonials

LED License Plate Light Set: Gen1

Reviews

OutMotoring!

Customer Service

Social Media

Contact Outmotoring

Legal

Be Social

Reviews

Testimonials

LED License Plate Light Set: Gen1

Reviews

OutMotoring!

Customer Service

Social Media

Contact Outmotoring

Legal

Newsletter Signup