For anyone considering these guage faces, be aware that the tick marks on the tach between 5500 and 6500 RPM do not light up properly without extensive modifications to the tach.
These camber plates are very well built structurally, improved the handling of the car dramatically, but IE built this unit around a very low quality bearing. By increasing the camber in the way that this unit does, it puts more load on the bearing and within only a couple months of installing it, the bearing becomes noisy, than gets sloppy, and than you car sounds like your front end is going to fall off on mild bumps. We installed these fixed camber plates following the instructions to the letter and within a few months, every set had to come off the cars they were on.
Vic Gregory
(Vehicle Programming)
I had a bit of disappointment today when my new hitch arrived - it was not the correct model for my car.
In retrospect, I looked back at the ordering page and found that it was my mistake but I could see why. I searched for a hitch for a Mini-S R53 and it took me to a 1001 which is for a non-S R50. The model numbers for the hitches and the cars they match up with were at the very bottom of the page, which I didn't see when ordering. It would have been very helpful if the drop-down menu had not just the hitch model number (1003) but the car model as well (R50, R53...) to help avoid this confusion.
It cost me return shipping and another week or more of wait. Not fun.
Douglas Thompson
(1956)
Fantastic Customer Service from Aaron!! He is always helpful when I make a purchase and especially when I have a question and make a phone call, he's always helpful to answer my questions about an item or a purchase I've made. Very knowledgeable. Highly recommend OUTMOTORING!!