I just installed the NM Engineering Lowering Springs and am extremely pleased both with the looks, ride and the handling. The car lowered approximately 1.2" and looks like the photos above. No rubbing or grinding at any time.
Ordered for the first time. My order arrived quickly and packaged with care. The headlight rings were easy to install and so were the tail light trim. Amazing product. Ordering again for sure. Thank you out motoring!
JC
These camber plates are very well built structurally, improved the handling of the car dramatically, but IE built this unit around a very low quality bearing. By increasing the camber in the way that this unit does, it puts more load on the bearing and within only a couple months of installing it, the bearing becomes noisy, than gets sloppy, and than you car sounds like your front end is going to fall off on mild bumps. We installed these fixed camber plates following the instructions to the letter and within a few months, every set had to come off the cars they were on.
Vic Gregory
(Vehicle Programming)
After buying LED Rear Tail Lights: GREY Union Jack: R56/7/8/9, one stopped working just after a year. These aren't cheap, and they should last more than a year. Since I purchased them over the 12 month mark, they are not covered under warranty. :( Customer service (Aaron) did work with me to get a new one at a discounted cost so I am thankful for that. So glad I purchased these from Outmotoring!
I just installed the 22 mm rear sway bar from NM Engineering and have to say it really performs like expected and advertised. It has high quality mounting brackets and has significantly reduced the understeer found in the stock Mini.
Was the above review useful to you? Yes (1)
/ No (2)
If you have purchased this item and would like to leave a product review please sign in to add your review.