GP2 Big Brake Kit: Front

If you've seen the new monster GP2 Calipers on a the GP Special Edition MINIs rolling around town and feel like you need to upgrade, this is the way to go. The GP2 Big Brake is an amazing kit and may even save your life! Technically there is no reason why these will not fit on any of the Gen1 or Gen2 MINI's as the hub assembly and attachment points are all the same between the two models, but you will have to at least have a 17" to clear the diameter requirements AND likely a low offset or the right spoke design/cross section of wheel in order to clear the depth of this kit. Installation may require some minor shaving of the rear trailing arm IF installed on a Gen1 MINI.

Kit includes:

1- 34336857907 Gp2 master cylinder
1- 34106858069  Caliper housing left
1- 34106858070 CALIPER HOUSING RIGHT
2- 34116858071
1- 34116858073 PROTECTION PLATE LEFT
1- 34116858074  PROTECTION PLATE RIGHT
2- 34206850536 Hex screw with collar
2- 34106786062 Expansion spring
4- 34116780506 Guide pin
2- 34116780507 Repair set brake caliper 
2- 34116780508 DUST CAP 
2- 34116780509 Ventilation valve 
1- 34356779356 Clip for brake pad wear sensor 
1- 34356858080

1- 34106860642