MINI Cooper Accessories | MINI Cooper S Parts | MINI Cooper S Accessories | MINI Cooper S Parts

Select your Model:
Select
Model:

Be Social

Reviews

Installed on a 2011 MCS. Very easy to install, except on 2011+. You must use your stock tube from the tubro due to two sensors being mounted in the tube. I trimmed down the AEM pipe to fit from the air box to the stock tube. AEM heat shield must also be trimmed on the N18 engine. The oil cap filler is closer to the front of the vehicle and will not allow proper bolt alignment without a trim. Overall outstanding.

Testimonials

These camber plates are very well built structurally, improved the handling of the car dramatically, but IE built this unit around a very low quality bearing. By increasing the camber in the way that this unit does, it puts more load on the bearing and within only a couple months of installing it, the bearing becomes noisy, than gets sloppy, and than you car sounds like your front end is going to fall off on mild bumps. We installed these fixed camber plates following the instructions to the letter and within a few months, every set had to come off the cars they were on.

Vic Gregory
(Vehicle Programming)